I'm not sure if there is a better way but here's how I did it. I've had a recent job where this was needed. Clearly, this would be no use for your laser cutting requirement. The only way to apply the crop of the mask is to Rasterise it and then you lose the curve and end up with a pixel layer. As you have probably found you can move the sides by dragging the handles but if you move them back the original curve is revealed. The initial mask is the bounding rectangle of the curve. It should probably be called a mask tool. ![]() Sorry, the Vector Crop Tool is misnamed (IMHO) it isn't a crop tool.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |